System information

Diagnostic Tests and Commands
5–8
MicroVAX 3100 Models 88/98 User Information
5C SHAC Not used on MicroVAX 3100, SHAC option only
62 console_QDSS Not used on MicroVAX 3100, QBUS systems only
63 QDSS_any Not used on MicroVAX 3100, QBUS systems only
81 Qbus_MSCP Not used on MicroVAX 3100, QBUS systems only
82 Qbus_DELQA Not used on MicroVAX 3100, QBUS systems only
83 QZA_Intlpbck1 Not used on MicroVAX 3100, QBUS systems only
84 QZA_Intlpbck2 Not used on MicroVAX 3100, QBUS systems only
85 QZA_memory Not used on MicroVAX 3100, QBUS systems only
86 QZA_DMA Not used on MicroVAX 3100, QBUS systems only
To run the diagnostic tests, enter either TEST or T followed by the test number.
You can specify optional parameters for some tests, but you would not do so normally. If
you decide to specify optional parameters, then the following conditions apply:
• Each test uses up to 10 parameters, no more than 7 may be inputted on a command
line.
Most of these parameters are assigned values automatically by the system. These
parameters are indicated by an asterisk (*) in the parameters column of (t9e).
• If a parameter can be assigned a value, the name of the parameter is shown in the
parameters column in (t9e).
You can use test 9E with the test number as a parameter to show a list of legal
parameters and valid values for the test number. For example, enter T 9E 30 to
show a list of legal parameters and valid values for test number 30
(Memory_Init_Bitmap).
• There is a dependency between some tests.
• Failures can occur if dependencies between tests are not followed.
• Any parameter not entered is given a default value. Enter T 9E nn, where nn is test
number to show defaults. During power-up testing or execution of any script of tests
(A0 to BF), the values of parameters are determined by the script, not defaults.
• You may dump the contents of a script by entering T 9E nn, where nn is a script to
dump. Scripts are always in range of A0 to BF (or 0 for the power-up script).