System information

Programming Parameters for DSSI Devices
E-8
VAX 4000 Model 108 User Information
PARAMS>SHOW UNITNUM
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
UNITNUM 0 0 Word Dec U
PARAMS>SET UNITNUM 10
PARAMS>SET FORCEUNI 0
PARAMS>SHOW UNITNUM
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
UNITNUM 10 0 Word Dec U
PARAMS>SHOW FORCEUNI
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
FORCEUNI 0 1 Boolean 0/1 U
6. Label the device with its unit number, using the unit number labels shipped with your
system.
Setting the Node Name
After entering the DUP driver utility for a specified device, you can examine and set the
node name for the device as follows.
1. At the PARAMS> prompt, enter SHOW NODENAME to check the node name of the ISE
to which you are currently connected.
2. Enter SET NODENAME SYSDSK (or enter the desired alphanumeric node name of up
to eight characters).
3. Enter SHOW NODENAME to verify the new node name.
This shows the steps for changing the node name of a specified device from the factory-
supplied name to SYSDSK.
PARAMS>SHOW NODENAME
Parameter Current Default Type Radix
--------- ---------------- ---------------- -------- -----
NODENAME R7CZZC RF72 String Ascii B
PARAMS>SET NODENAME SYSDSK