System information

Console Commands
VAX 4000 Model 108 User Information
A-21
command disables the scatter-gather map.
RECALL
Shows the current state of command
recall, either ENABLED or DISABLED.
RLV12
Displays all RL01 and RL02 disks that
appear on the Q22-bus.
UQSSP
Displays the status of all disks and tapes
that can be found on the Q22-bus that
support the UQSSP protocol. For each
such disk or tape on the Q22-bus, the
firmware displays the controller number,
the controller CSR address, and the boot
name and type of each device connected to
the controller. The command does not
indicate whether the device contains a
bootable image.
This information is obtained from the
media type field of the MSCP command
GET UNIT STATUS. The console does
not display device information if a node is
not running (or cannot run) an MSCP
server.
SAVED_STATE
Displays the values of non-volatile console
parameters, such as BOOT, BFLG, and
SCSI_ID.
SCSI
Shows any SCSI devices in the system
(disk drives, or compact disc drives, for
example).
SCSI_ID
Shows the SCSI ID of the SCSI
controller(s).
TRANSLATION
Shows any virtual addresses that map to
the specified physical address. The
firmware uses the current values of page
table base and length registers to perform
its search. It is assumed that page tables
have been properly built.
VERSION
Displays the current firmware version.