System information

HSD10 Operation
4-16
VAX 4000 Model 108 User Information
Command Description Parameter/Default (if
applicable)
TAPE, and SHOW UNIT commands.
SHOW DISK
Displays a listing of all physical disk
device names assigned with the CREATE
DISK or AUTOCONFIG commands.
SHOW DSSI_STATS
Displays a snapshot showing the DSSI
statistics at the moment the command is
issued
SHOW MAINTENANC
E
Shows the status of all devices under
maintenance.
SHOW STATS
Same as SHOW DSSI_STATS.
SHOW STRIPESETS
Displays information about all logical
stripesets.
SHOW TAPES
Displays a listing of all physical tape
devices created with the CREATE TAPE
or AUTOCONFIG commands.
SHOW UNIT
Displays information about all devices
mapped to (T)MSCP device names.
TAPETEST
Initiates the adapter's tape test utility.
Rebooting the system hosts is required whenever any SET CONTROLLER parameter
is modified.
__________________________ Note ____________________________
Digital strongly recommends maintaining a hardcopy listing of current HSD10
parameter settings, particularly those set by the SET CONTROLLER command.
This may be useful in recovering from hardware or other failure.
___________________________________________________________
Using the HSD10 Console Terminal
1. To display and use the console terminal procedures which follow, it is necessary to
plug your console terminal directly into the HSD10 console port as follows:
2. Power down the system and remove the cover of the enclosure as described in
Chapter 3.
3. Remove your console terminal connector from the system console port
(see Figure 2-7).
4. Plug the console terminal connector into the HSD10 console port (see Figure 4-1).
5. Power up the system.