System information

HSD10 Operation
VAX 4000 Model 108 User Information
4-13
HSD10 PARAMS Command Utility Summary of Commands
The HSD10 Command Utility is comprised of commands to set HSD10 and device
operating characteristics, define device mapping to hosts, and display current environment
information. This utility is accessed via DUP using a task name of PARAMS.
The StorageWorks Solutions HSD10 Array Controller User’s Guide, EK-HSD10-UG,
describes the HSD10 PARAMS Command Utility command set in more detail, including
information on allowed parameters and qualifiers. Table 4-5 summarizes this command set
and indicates default parameter values.
Table 4-5 HSD10 PARAMS Command Utility Summary
Command Description Parameter/Default (if
applicable)
ABORT
Ends a maintenance operation.
ADD STRIPESET
Groups a set of disk drives under logical
stripeset name.
AUTOCONFIG
Scans the SCSI bus connected to the
HSD10 and assigns physical names to the
devices found.
CLEAR DSSI_STATS
Resets DSSI statistics counters to zero.
CREATE DISK
Assigns a physical name to a single disk
device.
CREATE STRIPESET
Creates a logical name for a stripeset.
CREATE TAPE
Assigns a physical name to a single tape
device.
DELETE DISK
Deletes the physical name for a disk
device.
DELETE STRIPESET
Deletes a logical stripeset name.
DELETE TAPE
Deletes the physical name for a tape
device.
DELETE UNIT
Deletes a (T)MSCP device name.
DESELECT
Returns a device to the pool of physical
devices.
DISKTEST
Initiates the disk test utility.
EXIT
Exits the Command Utility.
FACTORY
Used only by Digital services to restore
all adapter and device configuration
settings to their factory defaults via an on-