System information

HSD10 Operation
4-10
VAX 4000 Model 108 User Information
__________________________ Note ____________________________
HSD10 adapters normally come preconfigured and require no configuration changes
except to suit specific customer requirements. Non-preconfigured HSD10 adapters
require use of the front panel communications port to enable logical connection to
the DSSI and SCSI buses; see the SET PORT command in Appendix A.
___________________________________________________________
In the following sections, user input is shown in boldface type in the examples.
Starting PARAMS from the Console Prompt on OpenVMS VAX Systems
Use the following procedure to start PARAMS from the console prompt on OpenVMS
VAX systems:
1. At the console prompt, enter the SHOW DEVICE command as shown in the following
example:
>>> SHOW DEVICE
DSSI Node ID 0 (DSSI nodename)
DSSI NODE ID 5 (*)
UQSSP Disk Controller 0 (772150)
-DUA0 (RA82)
Ethernet Adapter
-ESA0 (08-00-2B-13-80-85)
This is the HSD10 DSSI-to-SCSI bus adapter. The DSSI nodename is initially a
six-digit number. Do not confuse this number with the DSSI ID value.