Owner`s manual

1. INTRODUCTION
Congratulations on selecting the Vector™ Model TVEC012 Start-It Jump-Start System. This system is an
advanced power and jump-start system with unique features that set it far above the value and utility of
ordinary jump-starters. It supplies DC for 12 Volt appliances to 20 amps. It can jump-start any vehicle
with a standard 12 Volt DC electrical system: boat, truck, car, airplane, RV, personal watercraft,
snowmobile, tractor, etc.
This advanced design is for serious work during emergencies and it can also enhance your fun by
powering DC appliances on the road, at the beach and at camp. Be sure to read and understand all
WARNINGS and CAUTIONS before using this product. Please read this guide carefully before use to
ensure optimum performance and avoid damage to the system or items that you are using it with.
The built-in LED area light is invaluable when it becomes necessary to locate battery terminals while
preparing to jump-start a dead battery in the dark. An audible polarity alarm warns of incorrect con-
nections while preparing to jump-start a dead vehicle battery.
It is also ideal for use with Vector™ 12 Volt DC cordless, portable, rechargeable appliances with ratings
up to 20 amperes. For information about Vector appliances, contact Vector™ Customer Service for the
location of the nearest retailer.
The unit has an easy-to-read, digital voltmeter that displays the battery level. The digital display activates
whenever the charge status pushbutton is pressed and it displays the battery voltage. The display acti-
vates automatically during recharge operations to show a circulating pattern. The display shows FULL
when the battery is completely charged.
One 12 Volt DC accessory socket is provided for use with appliances that can operate from a 12 Volt DC
accessory socket. The DC accessory socket allows for DC recharge from a vehicle or other 12 volt acces-
sory socket. Note that the exposed electrical socket and recharge port have covers that help keep out dirt,
dust and moisture. All covers must be open for socket or port use; closed after use.
FIGURE 1 Switches, Indicators and Ports on top Panel
Switches, LED indicators and ports are located on the top panel.
The Safety Power Switch (OFF/ON) is located on the upper right side of the panel. When it is in the OFF
position, the cable clamps are not powered and the reverse polarity alarm system is enabled and ready
to sound, if connected to an incorrect polarity. A small red LED above the Vector Logo also indicates
Reverse Polarity.
On top of the Area Light “dome” is a slide switch that turns the Area Light ON and OFF. The Area Light
is powered ON when the ON/OFF slide switch is moved to the right hand side. The Area Light provides
the user with light while changing a tire, and connecting battery clamps. The area light is a long lasting
lamp and will continuously operate for three days from a fully charged battery.
2
12 Volt DC
accessory
socket
Battery status
display
pushbutton
Digital LED voltage display
(battery status display)
Recharge
port
Reverse
polarity LED
Area light
switch
On/Off power
safety switch