Owner`s manual

7
MAKE SURE ALL SWITCHES ARE IN THE OFF POSITION DURING RECHARGING. THIS MAY SLOW
RECHARGE.
To check the battery status, press the Battery Status Display Pushbutton. If the Jump-starter’s battery is fully
discharged, it is recommended that the host vehicle or boat’s engine being used for recharging be left
operating while the unit is being charged using the 12 Volt DC/DC method.
WARNING: DO NOT RECHARGE UNIT FOR MORE THAN 8 HOURS MAXIMUM USING 12 VOLT DC
METHOD.
5. MAINTENANCE/REPLACEMENT PARTS
For replacement parts, charging adapters, cables, etc., contact Vector™ Technical Support:
[phone]. There are no user serviceable parts inside Start-It. Periodically, the cables and
connectors should be inspected for damage, corrosion, dust and dirt. If surfaces are dirty, they can be
wiped clean with a cloth moistened with water and a drop of detergent. Clamp contacts can be wiped
clean with a dry cloth.
WARNINGS
THERE ARE NO USER SERVICEABLE PARTS INSIDE. DO NOT OPERATE UNIT IF THERE IS ANY
EVIDENCE OF DAMAGE. THE PRODUCT MUST BE RETURNED TO VECTOR FOR TESTING
AND REPAIR. REPLACE ANY DAMAGED CABLES AND CHARGING ADAPTERS IMMEDIATELY
BEFORE FURTHER USE.
6. SAFE BATTERY DISPOSAL
Contains a maintenance-free, sealed, non-spillable, lead acid battery, which must be
disposed of properly. Recycling is required -contact your local authority for information.
Failure to comply with local, state and federal regulations can result in fines, or imprisonment.
For more information on recycling this battery, call toll-free 1-877-288-7722
Battery Disposal Warnings
• Do not dispose of the battery in fire as this may result in an Explosion.
• Before disposing of the battery, protect exposed terminals with heavy-duty electrical tape to
prevent shorting (shorting can result in injury or fire).
• Do not expose battery to fire or intense heat as it may explode.
7. SPECIFICATIONS
Jump-start Clamps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .400 Amps - Heavy Duty Copper
Jumper Cables . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Heavy Duty Welding Cable
Peak Amps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1200
Instant Amps . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .400
Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 Volt 19 Amp Hour, Sealed Lead-Acid
Area Light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Three High Intensity White LEDs
Accessory Socket Protection . . . . . . . . . . . . . . . . . . . . . . . . .20 Amp Self-Resetting Breaker
AC/DC Recharge Adapter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12 Volt DC@700 mA
Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12.75 in (32.39 cm)
Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11.00 in (11.26 cm)
Depth . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5.5 in (13.97 cm)
Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .16 lbs (7.26 kg)
ALWAYS RECYCLE
PRBA
PRBA