Owner`s manual

5
A. Connect negative (-) black clamp to vehicle battery’s negative terminal.
B. Connect positive (+) red clamp to vehicle chassis or a solid, non-moving, metal vehicle component
or body part. DO NOT clamp directly to positive battery terminal or moving part.
12. Replace worn or defective parts immediately - contact Vector Technical Support Department at (954)
584-4446 or toll free at 866-584-5504.
13. Skin: if battery acid comes in contact with skin, rinse immediately with water, then wash thoroughly
with soap and water. If redness, pain, or irritation occurs, seek immediate medical attention.
14. Eyes: if battery acid comes in contact with eyes, flush eyes immediately for a minimum of 15
minutes, seek immediate medical attention.
2.2. Jump-start Procedure
1. Turn Off ignition and all accessories (radio, a/c, lights, cell phone, etc). Place vehicle in “park”
and set the emergency brake.
2. Make sure the unit’s Power Switch is turned OFF.
3. Observe jump-starting negative or positive ground system, as follows: Negative ground (negative
battery terminal connected to chassis) - most common.
4. Make sure Start-It’s Power Switch is turned OFF.
5. Carefully lift negative (black) jumper cable wire from storage channel starting at clamp end of cable.
6. Squeeze negative (black) clamp handle and remove clamp from holster.
7. Carefully lift positive (red) jumper cable wire from storage channel starting at clamp end of cable.
8. Squeeze positive (red) clamp handle and remove clamp from holster.
9. Connect positive (+) red clamp to vehicle’s positive battery terminal.
10. Connect negative (-) black clamp to chassis or a solid, non-moving, metal vehicle component or
body part - never clamp directly to negative battery terminal or moving part.
IF THE REVERSE POLARITY LED OR AUDIBLE ALARM SOUNDS, DO NOT TURN ON THE SAFETY
SWITCH. REVERSE THE CLAMP POSITIONS. ONLY TURN ON THE POWER SWITCH WHEN THE AUDI-
BLE ALARM IS SILENT AND THE RED LED IS NOT LIT.
11. Turn ON unit’s Power Switch.
12. Start vehicle (crank engine in 5-6 second bursts). If engine won’t start, seek help and go to step 15.
13. After vehicle starts turn the Power Switch to OFF position.
14. Leave engine running.
15. Remove clamps (disconnect the negative (black) clamp first; followed by the positive (red) clamp and
store cables and clamps).
16. Squeeze negative (black) clamp handles and slide clamp into holster.
17. Carefully press negative (black) jumper cable wire into storage channel.
18. Squeeze positive (red) clamp handles and slide clamp into holster.
19. Carefully press positive (red) jumper cable wire into storage channel.
20. Recharge Start-It as soon as possible.
3. USE AS A 12 VOLT DC PORTABLE POWER SUPPLY
WARNING - NEVER INSERT A CIGARETTE LIGHTER INTO ACCESSORY SOCKET.
NOTE: Make sure that the Unit’s Power Switch is ALWAYS in the OFF position when using the unit’s 12
Volt DC accessory outlet.
1. Lift up the cover of the unit ‘s 12 Volt DC socket.
2. Insert the 12 Volt DC plug from the appliance into the 12V DC accessory socket on the unit.
3. Switch on the appliance, as usual.
4. Periodically press the Battery Level Status Pushbutton to check battery status. When the battery level
reads 10.5 volts, you must recharge it as soon as possible.