Technical data

22
REQUIREMENTS
 Do not disconnect the batteries with the engine running.
 Do not carry out arc welding operations in the vicinity of the engine
without first removing electrical cables and electronic units.
 After each maintenance operation involving disconnection of the
batteries, make sure that the terminals have been properly locked
onto the poles.
 Do not use battery chargers to start the engine.
 Disconnect the on-board network batteries when recharging.
 Do not paint the appliances, components and electrical connectors
equipping the engine.
 Disconnect the batteries before any electrical operations.
 Contact the Boatyard before installing electronic equipment on
board (two-way radios, echo-sounding equipment, etc.).
HOW TO PROCEED
Checking oil level in engine
Only proceed with the engine stopped and at a low temperature, so
as to avoid the risk of burning.
 Using the dipstick, check that the oil level is between the "Min" and
"Max" levels.
 If the level is too low, top up through the inlet on the side of the
engine, after first removing the relevant cap.
Checking oil level in marine gear
Check the oil level in the marine gear following the indications provid-
ed in the marine gear Manufacturer's manual.
Checking coolant level
When testing, it is prescribed that the engine be inclined by an amount
corresponding to its position during navigation.
 Make sure that there is a sufficient amount of coolant fluid, by
checking that the level indicator (1) is between the "Min" - "Max"
signs.
WARNING
 After topping up, make sure that the oil level does not exceed the
"Max" limit marked on the dipstick.
 Make sure that the dipstick is inserted properly and the filler cap
is turned in a clockwise direction until it stops turning completely.