Technical data

ENGLISH

Procedure for start-up from IVECO MOTORS

secondary control panel (fly-bridge)

1 Enable the secondary control panel, by turning the key switch on

the main panel to position 8B (see requirements and procedure

given in previous paragraph).

2. Wait for the beeper to stop sounding and for the alarm indicators

on the indicator module (5) to switch off, with the exception of the

“alternator malfunction” and “low oil pressure” indicators. At the

same time, check that the indicator test has been performed suc-

cessfully (information on how to interpret this test and indications

on the module are given in the relevant paragraph).

3. Press the green button (5) and release it.

4. When the engine has started, make sure that the rev indicator is

showing a plausible reading.

1. Rev counter and hour counter - 2. Beeper - 3. Indicator and alarm

module - 4. Button to disable the beeper - 5. Engine start button - 6.

Engine stop button.

WARNING

In order to ensure that the on-board control panels function properly

during navigation, it is essential that the engine only be started after

testing of the indicator lights and beeper has been completed.

1 3

04_355_N