Use and Care Manual

Operating the Engine
7-2
① Range gear shift lever.
(L) Low Range
(H) High Range
(N) Neutral position
(R) REVERS
2. Push the accelerator pedal down slowly.
① Speed control pedal
②＝＞③ INCREASE
③＝＞② DECREASE
3. Insert the key into the key switch and turn it
“START”.
OFF (Stop the Engine)
ON (Engine runs or headlights on)
START (Start the Engine)
IMPORTANT :
 It is not sufficient to do daily checks on dash
board only. Always conduct daily checks
carefully by referring to “DAILY CHECK“ in
“PERIODIC SERVICE” section.
4. Turn the key to “START” position and
release when the engine starts.
IMPORTANT:
 Because of safety devices, the engine will
not start except when the gear shift lever is
placed in the “NEUTRAL” position and the
brake is depressed.
■ Cold Starting
When the ambient temperature is below -
15℃( 5℉), the engine is very cold. If the engine
fails to start after 5 seconds, turn off the key for
30 seconds and start again.
STOPPING THE ENGINE
1. After slowing the engine to idle, turn the key
to “OFF”.
2. Remove the key.