Instructions / Assembly

Table Of Contents

Sport Mount Bracket - Strike 1000

INSTALLATION INSTRUCTIONS:

1. Locate and remove the rear 10mm bolts (A) that

secure the winch to the frame. Shown in Figure 1.

2. Remove the 2 rectangle plastic caps from the

frame tubing.

3. Loosely tighten the 10mm bolts from #1 above.

4. Adjust bracket so that both holes align to the

center of the frame tubing on the left and right

(B).

5. Drill (4) holes through the frame tubing so that

the hold down bracket can be slid into the tubing

and secured with the 100mm hardware.

6. When completed the bracket assembly should

look like Figure 2.

7. Torque all hardware to 20-25 ft.lbs.

Figure 2

Figure 1

10MM BOLTS AND NUTS TORQUE TO 20-25 FT.LBS.

Qty.

Fastener Components:

Part Description

4................. Hex Bolt M10x1.25x30mm

4................. Lock Washer M10

4................. Flat Washers M10

PART # 732001150500