Instructions / Assembly
Table Of Contents
Assembly Instructions
Position Lever ahead and turn the blade to the desired
position. The Lever will spring back when the blade is at
the correct angle.
The blade skids are adjustable so the blade can be
lowered but still held a certain distance off the ground.
The blade is designed to trip when it strikes an object or
digs in too far. When pressure is released the blade
springs back into position. Blade spring tension may be
set stiffer by tightening the Locknuts on the bottom of the
Eyebolts. For less spring tension, loosen the Locknuts.
Do not exceed 5 MPH with blade installed.
Operate with extreme caution on slopes, steep grades
and rough terrain.
Keep away from blade and moving parts during
operation.
When plowing snow or dirt into a pile, start backing up
before raising the blade.
Do not ram the blade into the pile ** SLOW DOWN
BEFORE HITTING THE PILE. **
Be aware of possible hidden objects under snow.
Wear head protection, safety glasses and shoes as
recommended in the machine's Operator's Manual.
Allow no riders on blade or machine while moving or
stationary.
Keep bystanders away from blade and machine while
moving or stationary.
When blade is not in use, turn of the engine, set and lock
brakes, and lower blade to down position.
Only mature adults over the age of 16 should operate the
machinery. Do not operate this machinery if you are
under the age of 16.
Please read and follow all of the instructions in the
owner?s manual.
Please read and follow all of the instructions in the
machine's operations manual.
Keep all bystanders a minimum of 15 Meters away from
the machine and Blade when it is in operation.
Do not use this equipment at night (in the dark) or under
poor weather conditions, unless your machine has
adequate lighting, which produces clear safe vision.
Due to the extra length of the blade, loss of directional
control may result when pushing heavy material.
Use with Caution!
A detailed listing of parts for this accessory kit is
provided on page 3-
6
. Use the list as a checklist to
inventory parts received. Please contact your local
HISUN dealer of any missing hardware.
! Due to reduced ground clea
rance remove plow Mount
Brackets before trail riding.
! Do not exceed 5 MPH with th
e blade or its brackets
installed
OPERATION TIPS
! When plowing snow or dirt into a pile, back away from
the pile before attempting to raise the blade
!
For best results set the suspension to the stiffest setting
if possible
! The Blade is shipped with the Blade Skids mounted
upside down for boxing. Be sure to mount the Skids
properly before using your blade.
MAINTENANCE
! Periodically check for wear and tightness of all bolts,
nuts and fasteners. Replace or tighten as necessary.
Grease all pivot points and hinges as needed