System information

Command Line Configuration
123
PHSETUP error handling
One or more of the following error messages may be returned if you supply
mode:interactive at the beginning of the command line call to PHSETUP.
 If you pass bad credentials to the /u or /x parameters, PHSETUP detects the failure to
connect to the settings, displays an error message, and then exits. Note that if you use a
bad user account name in adding an ACE (access control entry) to a security descriptor,
PHSETUP does not detect any problem. However, no change is made to the settings, and
PHSETUP silently exits.
 PHSETUP returns an error if you attempt to pass it an invalid keyword or if you pass an
invalid parameter to a keyword that accepts a limited set of values (such as on and off).
 No error information is reported if you pass an invalid parameter to any of the
following keywords:
addServiceSecurityACE
removeServiceSecurityACE
setServiceSecurityOwner
addAdminSecurityACE
removeAdminSecurityACE
setAdminSecurityOwner
addSettingsSecurityACE
removeSettingsSecurityACE
setSettingsSecurityOwner
addLicense
NOTE: Use mode:interactive at the beginning of the command line call to display
any error messages at all.