System information

Master Operation
51
IPv6 site-local addresses allow data to be sent only to the devices within a site or
organization. The site-local broadcast address is FF05::4000:1.
To locate a Host computer by polling a specific IPv6 multicast address within a site or
organization, follow these steps:
1 From the Manage Polling Ranges window, select Local Network UDP/IP and click New.
The Polling Ranges Definition window appears.
2 Select Broadcast to IPv6 site-local multicast address.
3 Enter a name for the search next to Descriptive Name.
4 To specify a UDP port number to use for polling, enter it in the Port field. The default
<Standard> port is 1505
5 To omit the search from the Ranges list located on the Peer-to-Peer Hosts tab, click
Hide this range on the Peer-to-Peer Hosts page.
6 Save your search using one of the following methods:
 Click Apply to save changes and leave the Polling Range Definition window open.
 Click OK to save changes and close the Polling Range Definition window.
Create a UDP/IP Poll single computer (at one IPv6 address)
To locate a Host computer by polling a specific IPv6 address, follow these steps: