System information

Master Operation
49
1 From the Manage Polling Ranges window, select Local Network UDP/IP and click New.
The Polling Ranges Definition window appears.
2 Select Scan IPv4 address range.
3 Enter the first address in your desired network polling range next to First Address.
4 Specify the size of the range by entering the number of addresses to search beyond
the First Address next to Number of addresses.
5 Enter a name for the search next to Descriptive Name.
6 To specify a UDP port number to use for polling, enter it in the Port field. The default
<Standard> port is 1505.
7 To omit the search from the Ranges list on the Peer-to-Peer Hosts tab, click Hide this
range on the Peer-to-Peer Hosts page.
8 Save your search using one of the following methods:
 Click the Apply button to apply changes and leave the Polling Range Definition
window open to create and save more UDP searches.
 Click the OK button to save changes and close the Polling Range Definition window.
Create a UDP/IP broadcast to IPv6 link-local multicast address