System information

PC-Duo Master Guide

1 From the Manage Polling Ranges window, select New > UDP/IP. The Polling Ranges

Definition window appears.

2 Select Broadcast to IPv4 address.

3 Enter the Host computer network address that you want to poll in the Address field.

4 Enter a name for the search next to Descriptive Name.

5 To specify a UDP port number to use for polling, enter it in the Port field. The default

<Standard> port is 1505.

6 To omit the search from the Ranges list located on the Peer-to-Peer Hosts tab, click

Hide this range on the Peer-to-Peer Hosts page.

7 Save your search using one of the following methods:

 Click Apply to save changes and leave the Polling Range Definition window open.

 Click OK to save changes and close the Polling Range Definition window.

NOTE: Select Broadcast to IPv4 address to search for remote Host computers by

sending a packet to a specific address. Note that broadcasts to other networks or

subnets only work if intervening routers are configured to forward broadcasts.

Create a UDP/IP scan IPv4 range of addresses

To locate one or more Host computers by polling a range of IPv4 addresses, follow these

steps: