Owner`s manual

8.2 TROUBLESHOOTING GUIDE

TROUBLE/ INDICATION POSSIBLE CAUSE SUGGESTED REMEDY

No AC output – DC input below 10 Volts Recharge or replace

red LED lit battery

No AC output – Excessive appliance Reduce load-wait for

red LED lit load-thermal shutdown inverter to cool. Turn Off

Low battery alarm Bad connection or wiringTighten all DC

sounds continuously connections

Low battery Low battery voltage Recharge battery

alarm sounds Remove load from

inverter while recharging

battery

Motorized power tool Excessive start-up load Rock the On/Off switch

won’t start several times. If appliance

does not start, then

appliance will not work

with inverter

Motorized power tool Purely inductive load Make the load not purely

does not operate at inductive. Operate an

correct speed incandescent lamp at

same time as motor

Television/Radio Snow in picture, buzz Keep inverter and

interference in speaker antenna distant from

each other. Use shielded

antenna cable. Connect

antenna to amplifier and

ground inverter case

FIGURE 1 – FRONT PANEL

FIGURE 2 – BACK PANEL

1) DUAL HIGH SPEED COOLING FANS

2) BLACK NEGATIVE (–) TERMINAL AND RETAINING NUT

3) RED POSITIVE (+) TERMINAL AND RETAINING NUT

4) TERMINAL COVER

1) THREE NORTH AMERICAN

STANDARD OUTLETS

2) GREEN LED SHOWS UNIT

IS OPERATING

3) RED LED SHOWS UNIT IS

SHUT DOWN

4) ON/OFF SWITCH

221