Instructions / Assembly

3
10. Remove adhesive backing from all the other
velcro strips, and apply pressure against the
mounting surface.
NOTE: Using a blow dryer to warm the area
of the machine and velcro is recommended
especially in cold weather. Maximum
adhesion occurs after 72 hours. It is
recommended that the adhesive be allowed
to set before the vehicle is used. Slight
adjustments may be required to adjust cab
enclosure to the desired position.
Removing the Cab Enclosure
1. Unzip the doors from the roof enclosure.
2. Carefully separate the velcro hook and loop
from the doors and the roof enclosure.
NOTE: When storing cab enclosure make
sure it is clean, (refer to the Maintenance
section for the proper procedure), fold
material in over windows, then roll, avoid
creasing the window material.
Cab Enclosure Cleaning
1. Use clean water with minimum detergent.
Cab Enclosure Protection
1. Spray with BoatSheen MicroGlaze which
provides ultra-violet light protection.
Clear Vinyl Window Cleaning
1. Use clean water with minimum detergent.
2. Scratched and cloudy vinyl may be rectified
with Vinyl Window Restorer.
Caution: Rigorously avoid household
glass cleaners that contain ammonia
or alcohol. These strip out the
plasticizer and lead to cracking.
Caution: Avoid contact with
hydrocarbon-based oils and waxes
(i.e. most waxes and oils), as these
cause yellowing.
Caution: Minimize use of detergents
because they can also leach out
plasticizers from the vinyl.
Maintenance & Service
TRAILERING YOUR UTV WITH ENCLOSURE INSTALLED IS NOT
RECOMMENDED AND MAY RESULT IN DAMAGE, OR ACCIDENT.
TRAILERING WITH ENCLOSURE INSTALLED WILL VOID
WARRANTY