User manual

Table Of Contents

Manual VN1600 Interface Family

3. Each of the two Piggybacks is fastened by a screw and retainer. Please loosen

the appropriate screw including the retainer and carefully remove the Piggyback

from the plug-in location.

Figure 20: Unmount/mount Piggybacks.

4. Set the DIP switches as described in section Pin Assignment CH1/3 and CH2/4

on page 18.

5. Insert the replacement Piggyback. When doing this please make sure that the

single and dual-row connectors are not laterally offset.

6. Secure the new Piggyback with the appropriate screw and retainer.

CH2

CH1