User manual

Table Of Contents

Manual VN1600 Interface Family

> CAN/LIN Piggyback inserted

If a CAN- or LINpiggy is inserted,

the Piggyback is assigned to CH1

(CH2) and the built-in CAN

transceiver is assigned to CH3

(CH4):

(1) 1051cap CAN Low

(2) Piggyback-dependent

(3) Piggyback-dependent

(4) Piggyback-dependent

(5) Shield

(6) 1051cap GND

(7) Piggyback-dependent

(8) 1051cap CAN High

(9) Piggyback-dependent

A: all ‚ON’ B: all ‚OFF’

Figure 13: Configuration with Piggyback.

Example: CANpiggy 1041mag

The following example shows the pin assignment of CH1/CH3 if a

CANpiggy 1041mag is inserted in the plug-in location 1 (Piggy 1).

Note: The described pin assignment is also valid for CH2/CH4.

A warning message will appear in the Vector Hardware Config tool if the DIP switch

settings are improperly set. Check your DIP switch settings in this case.