Full Product Manual

62
MAINTENANCE
Gear cases
Front Gear case
Always check and change the front gear case oil at the intervals outlined in the Periodic Maintenance
Chart beginning on page 59. Maintain the oil level even with the bottom thread of the fill plug hole.
Refer to the Gearcase Specifications Chart on page 54 for recommended lubricants,
capacities and torque specifications. See page 70 for the part numbers of HSUN products.
Oil Check
The front gear case fill plug is located on the left side of
the front gear case.
1. Position the vehicle on a level surface.
2. Remove the fill plug. Check the oil level.
3. Add the recommended oil as needed.
4. Rein stall the fill plug. Torque to specification.
Oil Change
1. Support the vehicle securely with a jack stand.
2. Remove the front tire on the driver's side.
3. Remove the fill plug.
Fill Plug
4. Place a drain pan under the drain plug.
5. Remove the drain plug. Allow the oil to drain
completely.
6. Clean the drain plug. Rein stall the drain plug.
Torque to specification.
7. Add the recommended oil.
8. Rein stall the fill plug. Torque to specification.
9. Check for leaks.
10. Discard used oil properly.