Full Product Manual

32
FAULT CODE
failure code Message Description
4481 Handbrake Fault
Handbrake is active when
direction selected.
4541 Fan Fault
No speed feedback from
external heatsink fans
4542 Low Oil Low Oil
4543 Hydraulic filter Hydraulic Filter
4544 Pump Current Low
Pump motor is not drawing
sufficient current
4545 Isolation Fault
Isolation fault detected between
logic and power frame
4546 No Motor Speed Signal No speed feedback from motor
4547 Tow Mode Tow mode has been activated
4548 Steer Sensor Warning Invalid steer sensor state
4549 Pulsed Enable
Pulsed enable signal not
present, unable to enable
bridge
454A Bridge Enable Delayed
Unable to complete power on
checks to allow the bridge to
enable
454B MOSFET s/c tests waiting
MOSFET / IGBT s/c tests at
power up are being held off
454C Electrolyte Low Level
Battery Electrolyte Low Level
detected
454D Electrolyte Cutout Level
Battery Electrolyte Low Level
detected and cutbcak
4581 Throttle Fault (Warn)
Warning level throttle fault.
Used for Renault Twizy
4582 Safety Case 1
Throttle appears to be stuck.
This fault will clear if throttle
starts to work again.
4583 Safety Case 2
Throttle appears to be stuck.
This fault will latch and can only
be cleared by repairing the
throttle and recycling power.
4584
Analogue Output Over Current
(warn)
Contactor driver over current
4585
Analogue Output Off with
Failsafe (warn)
Contactor driver not working
4586
Analogue Output Over
Temperature (warn)
Contactor driver over
temperature
4587
Analogue Output Under Current
(warn)
Contactor driver unable to
achieve current target in current
mode
4588
Analogue Output Short Circuit
(warn)
Contactor driver MOSFET short
circuit detected
4589 Analogue supply (warn)
Analogue supply is >10% out of
range
458A Seat (warning) seat regen settings applied
45C1 BDI Warning
BDI remaining charge
(0x2790,1) is less than BDI
Warning level (0x2C30,5)
45C2 BDI Cutout BDI remaining charge