Full Product Manual
Periodic Service
10-12
oil can be hot and can burn.
1. Park the vehicle on flat surface and remove
the seat, open the adjust hatch cover.
2. To drain the used oil, remove the drain plug
at the bottom of the engine and completely
drain the oil into an oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new oil up to the upper notch on
the dipstick.
(See “LUBRICANTS, FUEL AND
COOLANT” in “MAINTENANCE” section.)
Oil capacity
[Filter exchanged] 0.8L (1.89U.S. qts.)
[Filter non-
exchanged]
1.0L (1.68U.S. qts.)
~ Oil level is acceptable within this range
Dipstick Oil inlet
Drain plug
■ Replacing Engine Oil Filter
CAUTION
To avoid personal injury:
Be sure to stop the engine before
changing the oil filter cartridge.
Allow engine to cool down sufficiently,
oil can be hot and can burn.
1. Park the vehicle on a flat surface and raise
the cargo bed.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber
seal of the new filter.
4. After the new filter has been replaced, the
engine oil normally decreases a little. Make
sure that the engine oil does not leak
through the seal and check the oil level on
the dipstick. Then replenish the engine oil
up to the prescribed level.
[1] Engine oil filter
[2] Bolt
IMPORANT:
To prevent serious damage to the engine,
use only a genuine filter.