Full Product Manual

Periodic Service
10-8
new if they are loose tighten them as follows:
 Torque wheel bolts to 75 to 90 N.m
■ Cleaning air cleaner primary element
1. Remove the air cleaner cover and primary
element.
2. Clean the primary elements.
1） When dry dust adheres to the element blow
compressed air from the inside turning the
element. Pressure of compressed air must
be under 205kpa.
2） When carbon or oil adheres to the element
soak the element in detergent for 15
minutes then wash it several times in water
rinse with clean water and dry it naturally
after element is fully dried inspect inside of
the element with a light and check if it is
damaged or not.
3） Replace the primary element
Once yearly or after every sixth cleaning,
whichever comes first.
 First air cleaner  Air cleaner case
 Air cleaner element  Cover
IMPORTANT
 The air cleaner uses a dry element never
apply oil.
 Do not run the engine with filter element
removed.
 Be sure to refit the cower with the arrow (on
the rear of cower ) upright. if the cover is
improperly fitted the evacuator valve will not
function and dust will adhere to the element.
◆ Evacuator Valve
Open the air cleaner cover once a week under
ordinary conditions –or daily when used in a
dusty place-to get rid of large particles of dust
and dirt.
Check fuel line and fuel filter.
CAUTION
To avoid personal injury:
 Be sure to stop the engine and remove