Product specifications

7
C HAPTER 1: Q UICK S TART
R ECEIVING Y OUR S HIPMENT
If you find that any of the items are damaged due to shipment, please contact the
freight carrier immediately for assistance.
U NPACKING Y OUR C RESCENT V ECTOR
When you unpack your Crescent Vector system, please ensure that it is complete by
comparing the parts received against the packing slip. Unless your system has been
equipped differently than a standard Crescent OEM system, you should find the
following parts in your system:
• One Crescent Vector module (P/N 726-1049-XXX)
• One Crescent Vector OEM Integrator’s Manual CD (P/N 132-0132-XXX)
If you have purchased an Evaluation module, you will also receive:
• An Evaluation Enclosure, which includes an additional Crescent Vector
module with carrier board (P/N 802-1021-XXX)
• Two CDA3-RTK antennas (P/N 804-0023-XXX)
• Associated cables
Note - If, for some reason, you find a discrepancy between your packing
slip and the contents of your shipment, please contact the sales person
with which you placed your order immediately.
C ONFIGURING THE C RESCENT V ECTOR M ODULE
The Crescent Vector has four communication ports referred to as A, B, C and D. A, B
and C are fully independent and may have different message output at different
rates. Each of these ports may be configured for external correction input or output
binary message information or even RTCM corrections from an outside source. Also,
you may configure the output of ports A, B or C through any port A, B or C. Port D is
reserved for RTCM differential corrections, and may be used by the SBX-3B board.
NMEA 0183 M ESSAGE I NTERFACE
The Crescent Vector module uses a NMEA 0183 interface for interfacing, which allows
you to easily make configuration changes by sending text-type commands to the
receiver.