User's Manual

User Manual Introduction
Caution: Electrical safety and data security of the Supply Equipment must be as-
sured by separate means and is not in scope of the product. In particular, effective
measures must be taken to avoid damage and injury caused by overload or short
circuit in the electric power installation independent from the vSECC.
Caution: Neither the monitoring of residual current and insulation, relay monitoring
(main conductor), especially sticking of the conductors; nor the cooling function
(use of the temperature sensors for monitoring), monitoring of battery and wire
and the performance limits in the vehicle; nor the monitoring of power electronics
incl. contactors (especially emergency shutdown devices) is in the scope of the
product and must therefore be assured by separate means.
1.2.3 Foreseeable Misuse
Caution: vSECC does not comply with the directive 2014/34/EU and must there-
fore not be used in explosion critical areas. Installation in mobile equipment or oper-
ation without adequate protection against weather and moisture is not allowed. The
electrical safety of the supply equipment is not in the scope of the vSECC function-
ality and must be assured independently by suitable measures such as insulation
monitoring, residual current detection, overload protection and circuit breaker. The
vSECC may only be installed and operated by qualified and instructed personnel,
who is familiar with the contents of this document and must have access to it at all
times.
1.2.4 Hazards
Caution: Supply Equipment operates under high voltage which could also occur at
the product in case of failure and cause heavy injury and damage. Wrong configu-
ration and/or operation of the product may cause failures of the Supply Equipment
leading to personal injury or damage to property.
Comply with safety standards and public regulations which are relevant for the
operation of the system. Before you can operate the system in public areas, it
should be tested on a site which is not accessible to the public and specifically
prepared for performing tests in order to reduce hazards.
1.2.5 Disclaimer
Caution: Claims based on defects and liability claims against Vector are excluded
to the extent damages or errors are caused by improper use of the controller or
use not according to its intended purpose. The same applies to damages or er-
rors arising from incorrect mounting, insufficient training or lack of experience of
personnel using the controller.
© Vector Informatik GmbH Version 1.2.0 8