User's Manual
Table Of Contents
User Manual Introduction
1.2 Important Notes
1.2.1 Safety Instructions and Hazard Warnings
Caution: In order to avoid personal injuries and damage to property, you must
read and understand the following safety instructions and hazard warnings prior to
installation and use of the product. Provide this documentation (manual) to every
user of the product.
1.2.2 Proper Use and Intended Purpose
The Supply Equipment Communication Controller vSECC is used for communi-
cation between the charge controller of the vehicle to be charged and the supply
equipment via the charging cable and Type 2 CCS plug connections provided for
this purpose. Based on the received and transmitted information, messages for
interaction with the supply equipment operator and for controlling the power elec-
tronics are exchanged with other components of the supply equipment. The con-
troller also sends messages to the back end of the charging station, the Charging
Station Management System.
Caution: The product is designed for permanent, fixed installation in closed control
cabinets and stationary charging equipment. The installation environment must be
dry and protected from the weather.
Caution: Only specifically qualified, trained and authorized personnel is allowed
to install, set up, configure and operate the product to prevent accidents from haz-
ardous electrical voltage or electrical power. Access to operating products must
be limited to authorized personnel at any time. The housing of the product must
always be assembled during operation.
The device may only be used with appropriate connectors. The connectors of the
vSECC may only be used and operated within the specified range, the information
in the manual must be observed.
The product can be integrated into an existing IT infrastructure. The configuration
of the respective parameters and IT security is the responsibility of the customer.
Caution: vSECC contains components and circuits that communicate with other
components and circuits that can store and transform energy. The user has to take
care of the resulting dangers and make a separate risk assessment. The device
may only be operated within the specified temperature range.
© Vector Informatik GmbH Version 1.2.0 7