User's Manual

User Manual User Guide

Rebooting the system may take up to two minutes.

Figure 16: Maintenance Mode On

Use the [Save] button in the upper right corner to save your changes to the configuration.

Pushing the [Open previous configuration] button will load the previous configuration into the

current view, allowing you to easily compare settings between firmware updates. You can

press the [Save] button to apply the displayed previous configuration. To reset the configu-

ration to factory defaults, press [Reset changes]. Be aware that resetting to factory defaults

will permanently overwrite all custom changes made before. Other than the described but-

tons, the view also contains four more sections:

> Standard Components

> EVSEs

> Log Files

> Certificate upload

The ”Standard Components” section contains configuration variables which apply to the en-

tire vSECC application, such as the address of the CSMS. Chapter 3.5 gives an overview

of the available variables. All settings specific to an EVSE can be found inside the ”EVSEs”

section. To assist technical support, the vSECC application’s log files can be downloaded

from the vSECC within the ”Log Files” section. The ”Certificate upload” section allows in-

stalling additional Root-CAs on the vSECC.