User's Manual

User Manual VC-EVCC

Manual Configuration

Reprogramming is also possible without CANoe/CANalyzer. In this case, the following

CAN Messages (UDS/ TP) must be sent on the diagnostic CAN (CAN0) manually:

CAN-Identifier:

Tester --> VC-EVCC, Request: 0x610

VC-EVCC --> Tester, Response: 0x612

Tester --> Functional: 0x614

1. Extended Session:

Request: 02 10 03 FF FF FF FF FF

Response: 06 50 03 00 32 01 F4 FF

2. Tester Present:

Request: 02 3E 00 FF FF FF FF FF

Response: 02 7E 00 FF FF FF FF FF

Caution

The message “Tester Present” has to be sent cyclically in order to keep the VC-EVCC

in the extended session. Otherwise the extended session will be terminated after

approximately 4 – 5 seconds.

3. Charge Node Selection:

XX:

- 0x00: Charging Arbitration is inactive

- 0x01: Charging Arbitration is active

Request: 04 2E FD 14 XX FF FF FF

Response: 03 6E FD 14 FF FF FF FF

Note

In some cases the response message might include the value “AA” instead of “FF”.

In order to read the present configuration of the Charge Node Selection configuration, the

following communication has to be executed.

4. Read Charge Node Selection configuration:

Request: 03 22 FD 14 FF FF FF FF

Response: 04 62 FD 14 XX FF FF FF