User's Manual

User Manual VC-EVCC

Manual Configuration

Reprogramming is also possible without CANoe/CANalyzer. In this case, the following

CAN Messages (UDS/ TP) must be sent on the diagnostic CAN (CAN0) manually:

CAN-Identifier:

Tester --> VC-EVCC, Request: 0x610

VC-EVCC --> Tester, Response: 0x612

Tester --> Functional: 0x614

1. Extended Session:

Request: 02 10 03 FF FF FF FF FF

Response: 06 50 03 00 32 01 F4 FF

2. Tester Present:

Request: 02 3E 00 FF FF FF FF FF

Response: 02 7E 00 FF FF FF FF FF

Caution

The message “Tester Present” has to be sent cyclically in order to keep the VC-EVCC

in the extended session. Otherwise the extended session will be terminated after

approximately 4 – 5 seconds.

3. Secondary J1939 Source Address:

XX: Selected Secondary J1939 Source Address value

Request: 04 2E FD 10 XX FF FF FF

Response: 03 6E FD 10 FF FF FF FF

Note

In some cases the response message might include the value “AA” instead of “FF”.

In order to read the present Secondary J1939 Source Address configuration, the following

communication has to be executed.

4. Read Secondary J1939 Source Address configuration:

Request: 03 22 FD 10 FF FF FF FF

Response: 04 62 FD 10 XX FF FF FF