User's Manual

User Manual VC-EVCC

Manual Configuration

Reprogramming is also possible without CANoe/CANalyzer. In this case, the following

CAN Messages (UDS/ TP) must be sent on the diagnostic CAN (CAN0) manually:

CAN-Identifier:

Tester --> VC-EVCC, Request: 0x610

VC-EVCC --> Tester, Response: 0x612

Tester --> Functional: 0x614

1. Extended Session:

Request: 02 10 03 FF FF FF FF FF

Response: 06 50 03 00 32 01 F4 FF

2. Tester Present:

Request: 02 3E 00 FF FF FF FF FF

Response: 02 7E 00 FF FF FF FF FF

Caution

The message “Tester Present” has to be sent cyclically in order to keep the VC-EVCC

in the extended session. Otherwise the extended session will be terminated after

approximately 4 – 5 seconds.

3. Message cycle time:

XX:

- 0x00: CAN Message isn’t transmitted

- 0x01 … 0xFF: CAN Message is transmitted with a cycle time of Value * 10ms

(10ms … 2550ms)

Request: 04 2E FD 0X XX FF FF FF

Response: 03 6E FD 0X FF FF FF FF

Note

In some cases the response message might include the value “AA” instead of “FF”.

The data identifiers (in blue) of CAN messages with configurable message cycle times are

listed below.

Message

Data Identifier (DID)

VCVCCU_PTC0

FD 04