User's Manual

User Manual VC-EVCC

8 Device Installation

Directly install the device using three M6 hex socket head screws with a minimum

engagement length of 7.2 mm. Tighten the installation screws with a torque of M = 9.5 –

11.5 Nm. It is recommended to use spring washers or lock washers to secure the screws.

In general, the following minimum requirements for fastening the VC-EVCC to the vehicle

must be observed.

 Screw connection: M6

 Minimum engagement length of 7.2 mm in a steal thread/ nut M6 DIN934

 Strength class screw: 8.8

 Tightening torque: 9.5 – 11.5 Nm

Figure 8-1: Installation