User's Manual

User Manual VC-EVCC

The signal VCVCCU_ChargeUnit_State is set to mode B if

 LINAwake is set to 0 OR

 A sleep frame has been received from EVSE via LIN OR

 EVSE_StatusOp is set to Deny_V OR

 LIN communication has timed out for longer than ChargeLIN_NoLinTime OR

 Power outage was detected OR

 ControlPilot_ChargeComActv is set to active OR

 VCVCCU_Vehicle_ChargePermission is not set to allowed OR

 VCVCCU_PTC0_Temperature is not PTC_NormalTemperatureAC (only if PTC0 is

activated) OR

 VCVCCU_DigitalInput_DebouncedStatus is pressed OR

 ChargeLin_TerminationOnError is active OR

 VCVCCU_S3Switch_DebouncedStatus is pressed (only in case of Combo1) OR

 VCVCCU_Vehicle_StopCharge is either pressed or error (only if StopCharge CAN

signal is activated) OR

The ECU shall end the LIN session if

 VCVCCU_PlugPresent_Status is Not_Connected OR

 LIN communication has timed out for longer than ChargeLIN_NoLinTime OR

 Power outage was detected.

The ECU shall end the LIN session and go to sleep mode if

 a LIN sleep frame has been received from the EVSE.

The ECU shall set the LIN signal EvAwake to 0 in order to request LIN sleep at EVSE if

 ControlPilot_ChargeMode has changed from Mode C to Mode B OR

 LINAwake changes from 1 to 0 (falling edge) OR

 DigitalInput_DebouncedStatus is pressed OR

 S3Switch_DebouncedStatus is pressed OR

 ChargeNode_Status is not set to selected (as described in PJ-SWREQ-183476) OR

 "StopCharge CAN Signal" is active and Vehicle_StopCharge is either

'Pressed' or 'Error' OR

 VCVCCU_PlugPresent_Status is Not_Connected