User's Manual

User Manual VC-EVCC
© 2021 Vector Informatik GmbH Version 1.3.0 201
5.5.8.21.4 DC_EVSEStatus Response Parameter
The CAN signals are filled with the parameters of the PowerDeliveryRes(Renegotiate)
according to the table below.
PowerDeliveryRes(Renegotiate)
CAN signal
DC_EVSEChargeParameter.DC_EVSEStatus.
EVSENotification
VCVCCU_V2G_EVSENotification
DC_EVSEChargeParameter.DC_EVSEStatus.NotificationMa
xDelay
VCVCCU_V2G_NotificationMaxD
elay
DC_EVSEChargeParameter.DC_EVSEStatus.DC_EVSEStat
usCode
VCVCCU_V2G_EVSEStatusCod
e
Table 5-62 PowerDeliveryReq(Renegotiate) CAN Signal Mapping
If the PowerDeliveryRes(Renegotiate) contains
DC_EVSEChargeParameter.DC_EVSEStatus.EVSEIsolationStatus the VC-EVCC
sets the value in the CAN signal VCVCCU_V2G_EVSEIsolationStatus and
sets the value of the CAN signal VCVCCU_V2G_EVSEIsolationStatusFlag to 1.
5.5.8.22 Power Delivery (FALSE)
The VC-EVCC proceeds with the PowerDeliveryReq(FALSE) if
VCVCCU_Vehicle_ChargePermission is not set to allowed or
VCVCCU_ChargeUnit_Mode is not ChargeV2G or
VCVCCU_PTC1_Temperature is not below ChargeV2G_MaxAllowedTemperature or
VCVCCU_PTC2_Temperature is not below ChargeV2G_MaxAllowedTemperature or
VCVCCU_DigitalInput_DebouncedStatus is pressed or
VCVCCU_S3Switch_DebouncedStatus is pressed (only in case of Combo1) or
VCVCCU_Vehicle_StopCharge is pressed (only if StopCharge CAN signal is
activated)
Vehicle_ContactorRequest is set to Open if the response code in the
PowerDeliveryRes(FALSE) was OK.