User's Manual

User Manual VC-EVCC

5.2.2 Reflashing the VC-EVCC

Reflashing can only be executed by using the Vector flash tool “vFlash”. vFlash is required

to install new software versions on the VC-EVCC. The flashing process with vFlash is

described in this chapter. Since there are different versions of vFlash the following two

vFlash Packs are provided.

 VC-EVCC_Vx.x.x

 VC-EVCC_Vx.x.x_vFlash3.0

The vFlash Pack “VC-EVCC_Vx.x.x_vFlash3.0” is used for vFlash version 3.0 whereas the

vFlash Pack “VC-EVCC_Vx.x.x” is used for newer vFlash versions than version 3.0.

Note

In preparation for the flashing process the VC-EVCC must be connected to power

supply. Furthermore, a Vector interface could be used as a CAN-Interface between

Tester and VC-EVCC.

1. Start vFlash and click on the button “Open”.