User's Manual

User Manual VC-EVCC

Manual Configuration

Reprogramming is also possible without CANoe/CANalyzer. In this case, the following

CAN Messages (UDS/ TP) must be sent on the diagnostic CAN (CAN0) manually:

CAN-Identifier:

Tester --> VC-EVCC, Request: 0x610

VC-EVCC --> Tester, Response: 0x612

Tester --> Functional: 0x614

1. Extended Session:

Request: 02 10 03 FF FF FF FF FF

Response: 06 50 03 00 32 01 F4 FF

2. Tester Present:

Request: 02 3E 00 FF FF FF FF FF

Response: 02 7E 00 FF FF FF FF FF

Caution

The message “Tester Present” has to be sent cyclically in order to keep the VC-EVCC

in the extended session. Otherwise the extended session will be terminated after

approximately 4 – 5 seconds.

3. Three-phase AC charging via LIN:

XX:

- 0x00: Three-phase AC charging is deactivated

- 0x01: Three-phase AC charging is activated

Request: 04 2E FD 22 XX FF FF FF

Response: 03 6E FD 22 FF FF FF FF

Note

In some cases the response message might include the value “AA” instead of “FF”.

In order to read the present three-phase AC charging via LIN configuration, the following

communication has to be executed.

4. Read three-phase AC charging via LIN configuration:

Request: 03 22 FD 22 FF FF FF FF

Response: 04 62 FD 22 XX FF FF FF