User's Manual

User Manual VC-EVCC

Manual Configuration

Reprogramming is also possible without CANoe/CANalyzer. In this case, the following

CAN Messages (UDS/ TP) must be sent on the diagnostic CAN (CAN0) manually:

CAN-Identifier:

Tester --> VC-EVCC, Request: 0x610

VC-EVCC --> Tester, Response: 0x612

Tester --> Functional: 0x614

1. Extended Session:

Request: 02 10 03 FF FF FF FF FF

Response: 06 50 03 00 32 01 F4 FF

2. Tester Present:

Request: 02 3E 00 FF FF FF FF FF

Response: 02 7E 00 FF FF FF FF FF

Caution

The message “Tester Present” has to be sent cyclically in order to keep the VC-EVCC

in the extended session. Otherwise the extended session will be terminated after

approximately 4 – 5 seconds.

3. Charging Schedules:

XX:

- 0x00: Charging Schedules are deactivated

- 0x01: Charging Schedules are activated

Request: 04 2E FD 37 XX FF FF FF

Response: 03 6E FD 37 FF FF FF FF

Note

In some cases the response message might include the value “AA” instead of “FF”.

In order to read the present Charging Schedules configuration, the following

communication has to be executed.

4. Read Charging Schedules configuration:

Request: 03 22 FD 37 FF FF FF FF

Response: 04 62 FD 37 XX FF FF FF