User's Manual

User Manual VC-EVCC

Manual Configuration

Reprogramming is also possible without CANoe/CANalyzer. In this case, the following

CAN Messages (UDS/ TP) must be sent on the diagnostic CAN (CAN0) manually:

CAN-Identifier:

Tester --> VC-EVCC, Request: 0x610

VC-EVCC --> Tester, Response: 0x612

Tester --> Functional: 0x614

1. Extended Session:

Request: 02 10 03 FF FF FF FF FF

Response: 06 50 03 00 32 01 F4 FF

2. Tester Present:

Request: 02 3E 00 FF FF FF FF FF

Response: 02 7E 00 FF FF FF FF FF

Caution

The message “Tester Present” has to be sent cyclically in order to keep the VC-EVCC

in the extended session. Otherwise the extended session will be terminated after

approximately 4 – 5 seconds.

3. Plug and Charge:

XX:

- 0x00: Plug and Charge is deactivated

- 0x01: Plug and Charge is activated

Request: 04 2E FD 26 XX FF FF FF

Response: 03 6E FD 26 FF FF FF FF

Note

In some cases the response message might include the value “AA” instead of “FF”.

In order to read the present configuration of Plug and Charge, the following communication

has to be executed.

4. Read Plug and Charge configuration:

Request: 03 22 FD 26 FF FF FF FF

Response: 04 62 FD 26 XX FF FF FF