User's Guide

10 APCD-LM011-A
2 Installing the NAP and the CAP
To Reconnect the UPS Battery
1. Open or remove the front and rear doors on the cabinet.
2. Pull the front cover off the UPS to expose the battery connection.
Figure 7 Exide 5119 UPS with Battery Disconnected
3. To reconnect the battery, plug the battery bank plug into the UPS receptacle.
Figure 8 Exide 5119 UPS with Battery Connected
4. Align the front cover in position and snap it back in place.
5. Place the breaker on the rear power distribution bar of the UPS in the “ON” position.
The UPS battery is fully charged before shipping.
6. Plug the UPS into the power source to maintain the charge in the battery.
battery bank plug
UPS receptacle
Push the connectors behind the
handle and replace the front cover