User's Guide

APCD-LM011-A 7
2
Installing the NAP and the CAP
The first step in setting up your LMS3200 network is to link the NAP to the CAP. WaveRider
recommends that you set up the NAP and CAP using the default settings initially. After the
network is operational, you can optionally change the network addresses to suit your needs
using the LMS Network Management System (NMS) software.
The basic procedure for setting up the LMS3200 system, including the CAP to NAP link, is as
follows:
1. Set up the CAP.
2. Set up the backhaul for the CAP to NAP link.
3. Set up the NAP.
4. Set up the NMS Workstation.
5. Configure SNMPc Server.
6. Initialize and configure the NMS software.
7. Verify the CAP and NAP link is operational.
8. Configure CCUs.
9. Configure and deploy EUMs in your network.
This chapter describes the procedures to set up the LMS3200 CAP to NAP components.