User's Manual

58 APCD–NC006–A
Table 7 Command-Line Shortcuts and Getting Help
Subnet Masks
Where a command requires you to enter a subnet mask, you can do one of the following:
• Enter it as a range, which is the number of bits (0-32 are valid) in the subnet mask.
• Do not enter it, and let the NCL1170 decide what value to use. Note that the NCL1170
does not necessarily pick the correct subnet mask.
Table 8 NCL1170 Command-line Syntax Descriptions
Type To do this...
? display the names of the root commands.
[command_name]? display the syntax for a command.
help display all the commands, their subcommands and the
parameters and options for each command.
help [command_name] display the parameters and options for the command.
!! repeat the last command that was executed.
ESC cancel the command you are typing.
Command Syntax Description
arp Displays the Address Resolution Protocol (ARP)
configuration information.
arp flush Removes the temporary ARP table entries from the
ARP table.
arp add aaa.bbb.ccc.ddd
aa:bb:cc:dd:ee:ff
Adds an entry to the ARP table. aaa.bbb.ccc.ddd is
the IP address of the entry that you want to add.
aa:bb:cc:dd:ee:ff is the MAC address associated
with the IP address.
arp del aaa.bbb.ccc.ddd Deletes a specified entry from the ARP table.
aaa.bbb.ccc.ddd is the IP address of the entry that
you want to delete.
bridge statistics Displays the bridge statistics (frames in, frames out,
etc.). Only available in bridging mode.
bridge table Displays the bridge table entries. Only available in
bridging mode.
bridge table flush Removes the learned entries from the bridge table. Only
available in bridging mode.