User's Manual

3 Installing the NCL1170
APCD–NC006–A 16
3.2.2 Setting the NCL1170 System Name
Use this procedure if you want to uniquely identify your system by either name or location.
To change the system name of the NCL1170
1. At the NCL1170> prompt, type <system name your_system_name> to name the
NCL1170 in your system.
TIP: We recommend that you use a system name that
uniquely identifies each unit, based on its location, its
purpose, or a combination of both. For example, a system
name, Station_firehall identifies the NCL1170 configured
as a Station and located at the firehall.
Example: To change the system name from NCL1170 to Station_firehall would
look like this:
NCL1170> system name Station_firehall
System name changed to: Station_firehall
Station_firehall>
2. Type <write> or <save> to save the settings to memory.
NOTE: In this User Manual, the command-line prompt will always be
shown as NCL1170>.
3.2.3 Resetting an NCL1170 to Factory Defaults
Use this procedure if the NCL1170 has already been configured for use elsewhere in your
network and you need to restore its factory settings.
To reset the factory defaults of the NCL1170
1. Connect the NCL1170 to a terminal or terminal-emulation software and at the
NCL1170> prompt, type <write erase> to reset the unit to its factory-default
settings.
2. Type <reboot> for the unit to recognize the factory-default settings.