User's Manual

3 Installing the NCL1170
APCD–NC006–A 15
3.2.1 Changing the NCL1170 Password
Use this procedure if you want to request a password before users log on.
For maximum security, we recommend that you set a unique password for each unit in your
network, and record all passwords on the Configuration Data Record for the group. Refer to
Appendix F for a copy of the NCL1170 Network Group Configuration Data Record.
To change the password of the NCL1170
1. At the NCL1170> prompt, type <system password>.
2. At the Enter Current Password: prompt, type the old password.
3. At the Enter New Password: prompt, type the new password.
TIP: Use a maximum of sixteen (16) alphanumeric
characters. Passwords are case-sensitive. For example,
“abc” is not the same as “aBc”.
4. At the Verify password: prompt, type the new password again.
The system will display a message that your password has been successfully
changed.
5. Type <write> or <save> to save the settings to memory.
Your session to change the password may be similar to the following example session:
NCL1170> system password
Enter Current Password: *******
Enter New Password: ****
Verify password: ****
System password has been changed.
NCL1170>
CAUTION: Remember to record the password in your Data Configuration Record.
Unlocking the NCL1170 can be a complicated process. If you forget your NCL1170
password, contact WaveRider Product Assistance.