User's Manual

3 Installing the NCL1170
APCD–NC006–A 14
3.2 Initializing the NCL1170
As the unit powers-up, and the initialization sequence begins, progress messages are
displayed on the terminal screen. When initialization is complete, you will receive a message
indicating that the system is operational, followed by the PASSWORD: prompt. The factory
default password for the NCL1170 is a <blank field>, although WaveRider recommends that
you assign an unique password to each NCL1170 in your network.
If the NCL1170 default password <blank field> is acceptable, Enter. Otherwise,
To change the password of your NCL1170, follow the instructions in Changing the
NCL1170 Password, on page 15.
To specify a system name for your NCL1170, follow the instructions in Setting the
NCL1170 System Name, on page 16.
To reload the default settings of an NCL1170 already configured for use elsewhere
in your network, follow the instructions is Resetting an NCL1170 to Factory Defaults,
on page 16. If the NCL1170 is a factory-configured unit, you can omit this step.
For each of these procedures, you must be connected to the NCL1170 and logged
into the device.