User's Manual

Appendix A NCL1135 Command-Line Syntax
APCD–NC003–1.0 59
ip telnet host(aaa.bbb.ccc.ddd) Establishes a Telnet session with a remote host to
access and control a remote computer.
host(aaa.bbb.ccc.ddd) is the IP address of the
remote host.
ip traceroute
destination(aaa.bbb.ccc.ddd)
Displays the route that the packets take to a remote
destination.
destination(aaa.bbb.ccc.ddd) is
the IP address of the remote destination. The maximum
is 30 hops. An asterisk (*) represents each unsuccessful
try. For example, 1 * * *. Press any key to stop the ip
traceroute output.
mode Displays the forwarding mode: Bridging or IP Routing.
mode bridging|routing Changes the forwarding mode.
bridging: connects two networks on the same subnet
(they have the same subnet address).
routing: connects two networks on different subnets.
radio Displays the radio configuration information.
radio channel Displays the radio channel.
radio channel (1–14) Changes the radio channel.
radio disable|enable Disables or enables the NCL1135 radio transmission
capabilities. The NCL1135 is factory-configured as
disabled to prevent accidental damage should it be
powered up without an antenna or load connected.
radio per
[single|continuous|reset]
Displays or resets the cumulative radio packet error rate
statistics to the screen. This command is available
during tests and normal operation.
• single displays the current statistics.
• continuous displays the statistics every one
second.
• reset resets the calculations.
radio rxtest start|stop Starts and stops the Radio Continuous Receive Test.
When you start this test, the Radio PER display is also
automatically started. Available only at the Station
NCL1135. Use this test to deploy a new Station
NCL1135 in an existing network.
radio txtest start|stop Starts and stops the Radio Continuous Transmit Test.
Available only at the Master NCL1135. Use this test to
set up a Master and Station for a new network.
radio txrx start|stop Starts and stops the Radio Transmit/Receive Loopback
Test. When you start this test, the Radio PER display is
also automatically started. Available only at the Master
NCL1135. Use this test for a new installation only.
radio reset Forces the NCL1135 to reset. If you reset the NCL1135
radio instead of shutting down, the statistics are not lost.
If you use this command, the link service is disrupted for
the duration of the test.
radio unitid Displays the NCL1135 unit ID.
Command Syntax Description