User's Manual

Appendix A NCL1135 Command-Line Syntax
APCD–NC003–1.0 57
bridge table timeout Sets the time-out value for entries in the bridge table. If
the NCL1135 receives no packet from the specified
entry’s address during the time-out period you set (for
example, 15 s), then it clears the address from the table.
Valid times are 10 to 1 000 000 s; the default is 300 s.
Only available in bridging mode.
dhcp mode [none|relay] Sets the NCL1135 to use Dynamic Host Configuration
Protocol (DHCP).
• none - disables DHCP Relay.
• relay - enables DHCP Relay.
Available only if the mode is set to routing.
dhcp relay [add|delete
ip_address ]
Adds or removes the IP address of a Dynamic Host
Configuration Protocol (DHCP) server. Available only if
the mode is set to routing and DHCP mode is set to
Relay.
interface|if statistics Displays configuration information and statistics for all
interfaces.
interface|if statistics
ethernet|radio|loopback
Displays configuration information and statistics for
each interface: Ethernet, radio, or loopback.
interface|if reset Resets the statistics for all interfaces.
interface|if reset
ethernet|radio|loopback
Resets the statistics for the specified interface.
ip Displays the IP configuration information.
ip address Displays the IP addresses for the Ethernet and radio
interface. In bridging mode, the IP address is for
management purposes only. An IP address is not
required to perform bridge functions. When in Bridging
mode, if you assign an IP address to the NCL1135, you
only need to assign it to the Ethernet interface, because
the radio and Ethernet are considered as one interface.
In routing mode, you must configure both addresses.
ip address ethernet
aaa.bbb.ccc.ddd [subnet mask]
Changes the IP address for the Ethernet interface for
routing or bridging. aaa.bbb.ccc.ddd is the IP address
for the Ethernet interface and
[subnet mask] is
specified in either dotted decimal format or number of
bits.
Command Syntax Description