User's Manual
Table Of Contents
- Preface
- 1 NCL1135 Overview
- 2 Network Considerations
- 3 Configuring the NCL1135
- 4 Testing
- 5 Deploying the NCL1135
- 6 Operational Statistics
- 7 Troubleshooting
- Appendix A NCL1135 CommandLine Syntax
- Appendix B Abbreviations and Terminology
- Appendix C Operating Channel Frequencies
- Appendix D NCL1135 Specifications
- Appendix E Configuration Data Record
APCD–NC003–1.0 41
6 Operational Statistics
After the NCL1135 is configured, you can obtain the radio Packet Error Rate (PER)
information in addition to the operational statistics on the NCL1135 interfaces, radio, and IP
protocol layer.
6.1 Displaying the Radio Packet Error Rate (PER)
Radio PER can be displayed at any time, including during tests. See Chapter 5,
Deploying the
NCL1135
, on page 35 for tests that use Radio PER to display statistics during testing.
To display the current Radio PER for an NCL1135 during normal operation,
type <radio per> or <radio per single>.
Table 1 defines how to interpret the Radio PER output.
At a Master NCL1135, you will receive output similar to the following. The following example
was taken at a Master NCL1135 communicating with two Stations (unit IDs 2 and 3).
master> radio per single
Unit Id Link Status Total # Received Total # Missed PER (%)
--------- ----------- ---------------- -------------- -------
2 UP 2 0 0
3 UP 2 0 0
master>