User's Manual
Table Of Contents
- Preface
- 1 NCL1135 Overview
- 2 Network Considerations
- 3 Configuring the NCL1135
- 4 Testing
- 5 Deploying the NCL1135
- 6 Operational Statistics
- 7 Troubleshooting
- Appendix A NCL1135 CommandLine Syntax
- Appendix B Abbreviations and Terminology
- Appendix C Operating Channel Frequencies
- Appendix D NCL1135 Specifications
- Appendix E Configuration Data Record
Chapter 5 Deploying the NCL1135
40 APCD–NC003–1.0
The information received from Radio PER during the Transmit/Receive Loopback test will be
similar to the following output. The following output is from a Master (unit ID 1) communicating
with two Stations (unit IDs 2 and 3).
master> radio txrx start
Tx/Rx test started
Unit Id Link Status Total # Received Total # Missed PER (%)
--------- ----------- ---------------- -------------- -------
2 UP 9 0 0
3 UP 5 0 0
Unit Id Link Status Total # Received Total # Missed PER (%)
--------- ----------- ---------------- -------------- -------
2 UP 827 53 6
3 UP 820 56 6
Unit Id Link Status Total # Received Total # Missed PER (%)
--------- ----------- ---------------- -------------- -------
2 UP 1689 85 4
3 UP 1679 91 5
Unit Id Link Status Total # Received Total # Missed PER (%)
--------- ----------- ---------------- -------------- -------
2 UP 2566 109 4
3 UP 2545 126 4
Unit Id Link Status Total # Received Total # Missed PER (%)
--------- ----------- ---------------- -------------- -------
2 UP 3423 141 3
3 UP 3411 149 4
[Radio TxRx Test On]
master> radio txrx stop
master>